The Starter kit $450 including GST for Australia
(Other countries less 10%)

The Starter kit has enough tools to get you going and remove accessible dents. It's a bit slower, but the end result is the same. You can still remove all but the hardest to reach dents with this kit.

Quarter bar:- Used to push out any open access dent.

Set of three medium rods:- These are used to get into areas that are a bit small for a quarter bar or where you need to work close up and a bigger bar would be uncomfortable.

Tap down tool:- This tool is used to tap down high spots sometimes made unintentionally while removing very difficult dents, pushing in the wrong spot, or just trying to work too fast. It will also tap down upward dents caused by a boot lid being closed on something too big, or bonnets closed with something left on top of the engine.

Place the tool on top of the high spot and give it a sharp tap with the handle of the trim clip removal tool.

Hanging links:- These hook into holes or slots in bonnet and boot frames. A rod is passed through the link and you now have some leverage to work on the dent.

Small rod:- This tool is used to get into slots in boot and bonnet frames etc.

Small splayed end tool:- Used to remove close dents in gaps and slots etc. Insert tool and remove dents by turning the tool.

Medium splayed end tool:- Use this to get around the edges of doors and under bonnet frame gaps. Also to remove sharp dents and creases.

Door jammer:- This devise will hold doors, boots and bonnets open where you want in order to work from the underside to remove dents. When removing dents it is most important that whatever you are working on is kept absolutely still in order to be in full control.

You can easily upgrade this kit to the Pro PDR kit at any time for the price difference.